Automatic feeding and cutting machine tool mold installation and setting [Ponse cutting machine].
Ponse automatic feed cutting machine tool die installation and adjustment:
1), at the start and stop interface of the oil pump, press the "manual operation" button to enter the manual operation screen.
2), activate the picture according to the operation activation button. Otherwise, the function operation key in this interface is invalid. (activating hand
After the operation interface, the outside button of the machine is invalid.)
3), knife mold to be installed on the placement of the pulling plate, press the pull plate to move forward "button, will be sent to the cutting area of die cutter.
4) by adjusting the height of the cutting plate according to the "rising point of the pressboard" or "falling down of the pressing plate", the cutting will be made.
The broken plate is close to the knife die. Then use the fixture or install Roth to fix the cutter die on the cutting pressure plate.
5), after installation is completed, press the button of "operation relieving" to relieve the activation state of this picture.
6) press the "home page" to return the pump's start and stop interface.