Home > Exhibition > Content

Cutting machine safety operation regulation [Ponse cutting machine]

May 07, 2018

Cutting machine safety operation regulation [Ponse cutting machine]


Safety operation rules for cutting machine

1. Attention should be paid to the operation.

1.1 when the cutting tool is set, we must first relax the set handle to make the lever contact with the cut point control switch. Otherwise, when the cutter sets the switch to ON, it can not produce the set action.

1.2 when working, the cutter should be placed in the center of the upper pressing plate as far as possible, so as to avoid the unilateral wear and tear of the machine and affect its life.

1.3 replacement of new cutters should be reset according to the setting method if the height is different.

1.4 when you cut the movement, please leave the cutting knife or chopping board, and do not use your hands to help the cutter die to avoid danger.

1.5 if the operator wants to leave the position temporarily, please turn off the motor switch so as to avoid the improper operation of others and cause damage to the machine and others.

1.6 please avoid overload use so as not to damage the machine and reduce the service life.

Two, the adjustments should be paid attention to:

2.1 after the mold setting is completed, the cutting material is placed on the rubber plate, then the cutter die is placed on the material, and the feeding plate is pushed into the cutting area.

2.2 the cutting switch is pressed at the same time with both hands. At this time the cutting press will be lowered and pressurized to the tool die, and then the position of the cutter can be cut back to the starting position automatically after cutting the material.

2.3 when the material is blanking, if the material is not completely cut, the cutting depth controller is adjusted and the "pressure system" is rotated to the clockwise reverse direction. If the knife die into the rubber plate is too deep, the "pressure system" is rotated to the counter clockwise direction. The longer the adjustment time is, the deeper the cutting depth is, and try to adjust to the knife mold slightly pressed into the rubber plate. Stop.

2.4 pull the feed plate out of the cutting area, remove the finished material, and complete a blanking process.

QQ图片20160611103752.jpg