Cutting machine specification [Ponse cutting machine]
1. first, the cutting depth controller is left-handed.
2., turn on the power switch, press the start button of the oil pump, cut off and run for two minutes to observe whether the motor rotates clockwise.
3. stacking the pull plate, rubber plate and cutter die in the middle of the worktable.
4. tool setting:
A. loosens the handle of the knife.
B. set the switch to the right side, and the upper platen automatically descends until it is stationary.
C. pull the handle up and down to the lowest position to lock.
D. twist the set switch to the left side, and the upper pressure plate rises automatically.
E. press the green working button at the same time to make the test, and the blanking depth is controlled by fine adjustment.
F. fine-tuning: turn the fine adjustment button, turn left to shallower and deepen dextral. (tailored to make a fine tune)
G. rising height adjustment: the rotation height controller, the right-hand stroke increases, and the left stroke reduces. When the normal production is applied, the above pressing plate is suitable for the distance from the top of the die.