Home > Exhibition > Content

How to adjust the rising height of automatic feed cutter? [Ponse cutting machine]

Apr 16, 2018

How to adjust the rising height of automatic feed cutter? [Ponse cutting machine]


The 1. rise height is set at the height of the high die working area as the base point. Even if the height of the rise is set to "0", the rising height of the press plate is also at the slow point in the high die working area. At this time, the rise height of the low die working area is ineffective, so the height setting of the AB area is actually the same parameter when the height adjustment is set in the man-machine interface parameters.

2., the purpose of the above design is to prevent the high tool die entering the working area, and collide to the cutter die due to the low rising height of the pressboard.

3. note: when using only a single workspace, the height setting is unable to lower the platen height. We must set the height of working side below the working side to raise the height of the low voltage board.

4., due to the rising height setting, the input range is "0~60", which may appear above 30.

Up to the highest position, it is because the machine depends on time to control the height of the rise, when the pressure plate up to the upper limit switch maximum stroke time is less than the set up height time value.

24.jpg