Home > Exhibition > Content

How to carry out routine maintenance for hot melt adhesive composite machine?

Apr 02, 2018

The composite machine is a big industry, with special material and special leather, which can be applied in almost all light industry, which does not include metal material.

Today Xiaobian will share with you the most commonly used knowledge of the use and maintenance of hot melt adhesive machine.

Adhesive technology for hot melt adhesive composite machine

1., when using hot melt adhesive machine, do not put other debris on the body or use it as a high padding appliance.

2. to move or lift hot melt glue machine, only allow the use of its base as the moving point, must not use the hot melt glue machine glue pot cover, electric box door, electrical components on the control panel or the joint on the insulation pipe as auxiliary and lift the hot melt glue machine, unnormal handling will damage the hot melt adhesive machine spraying equipment.

Do not disassemble and check any parts on the hot-melt adhesive compound machine unless you know enough about the performance of the equipment. At the same time, remember that only qualified personnel can repair and maintain the hot-melt adhesive machine. The following main safety precautions should be taken when maintaining the hot melt adhesive machine.

Before the replacement of components of element protection 1. removing or moving hot melt machine on the device or, you must first cut off the power supply.

2. when loosening or installing pressure joints, it must be determined that the pressure for hot melt adhesive machine to provide pressure gas source has been reduced to zero.

3., in any case, do not touch the wires or joints that may be exposed to the outside world or other components that are not connected to the wires.

4., when cleaning hot melt adhesive cylinder, avoid using fireworks or sharp rigid tools, so as to avoid scratching the Teflon non adhesive coating inside the plastic barrel.

5. before the maintenance and maintenance of hot melt glue machine, it is necessary to cut off the power of the hot melt adhesive mechanical power and the total power connected to the outside, and not be charged.

6. in the disassembly and maintenance work, workers should not wear earrings, watches, necklaces, bracelets and other conductive ornaments, to prevent accidents.

7., if possible, try to work on plastic blankets for maintenance. Never maintain the hot-melt adhesive machine in a flooded floor or very wet environment.