Home > Exhibition > Content

How to correctly install and wire the cutting machine?

Jul 30, 2018

How to correctly install and wire the cutting machine?


How to correctly install and wire the cutting machine? As a kind of mechanical equipment, the precision four-column hydraulic cutting machine naturally has the problem of installation. The correct installation is related to the normal use and life of the cutting machine, so it is very important. As a well-known cutting machine manufacturer in China, the installation of precision four-column cutting machine can be summarized into the following six steps: 1. Use a wire rope to tie the lifting shaft above the pressure plate, use the lifting equipment to transfer the cutting machine to the installation site, or use a forklift to shovel the underside of the workbench. 2. Remove the oil paper on the work surface, clean the relevant parts with the cleaning oil, and level the level. 3. Open the front sealing plate of the cutting machine and inject 46# lubricating oil into the fuel tank. The hydraulic oil must be higher than the oil filter 2-3CM. 4. Connect the cutting machine to the 380V, 50HZ power supply according to the electrical principle and requirements of the cutting machine, and ground it reliably. 5. Turn on the motor start button. Check the adjustment so that the flywheel steering is consistent with the steering sign on the motor. Run for two minutes, then try again with an empty load. 6. Press the stop button and the cutter stops running. In the process of installing the precision four-column cutting machine, if we can strictly follow the above six parts, I believe that the cutting machine can be properly installed.