Home > Exhibition > Content

How to operate the automatic feeding cutter after troubleshooting?

Apr 17, 2018

1), when the pull plate motor or oil pump motor thermal overload relay protection operation, after troubleshooting, press the thermal overload relay reset button to reset.

2), if it is "over cut protection protection action", after troubleshooting, then press the "reset reset" ammonium button to reset, and the buzzer stops alarm. (if this is often the case, at the same time, you use a large tool die and a stretch of elastic cotton next to the edge of the knife, setting the height of the knife die setting is not in place, can appropriately increase the protection value.)

3), if the inverter is abnormal, after troubleshooting, it can be restarted and reset.

6-7.jpg