Pearl Cotton Factory Equipment - Pearl Cotton Cutting Machine
Pearl Cotton Factory Equipment - Pearl Cotton Cutting Machine Polyethylene foamed cotton is a non-crosslinked closed-cell structure, also known as EPE pearl cotton, which is a new environmentally friendly packaging material. It consists of low density polyethylene glycol by physical foaming to produce a myriad of independent bubbles. It overcomes the shortcomings of common styrofoam, such as fragility, deformation and poor recovery. It has many advantages such as water-proof, moisture-proof, shock-proof, sound-proof, heat preservation, good plasticity, toughness, recycling, environmental protection, strong impact resistance, etc. It also has good chemical resistance. It is an ideal substitute for traditional packaging materials. Cutting machines are indispensable equipment for some light industry. Traditionally, the cutting machine is a machine that pressurizes a non-metallic material by means of the force of the machine motion. Cutting machine range: suitable for foaming materials, cardboard, textiles, plastic materials, leather, rubber, packaging materials, flooring materials, carpets, fiberglass, cork, shoes, handbags and bags, gloves and hats, crafts and silk flowers Non-metallic materials such as embroidery, jigsaw and card making, plastic and packaging, printing and paper products, stationery, automobiles and electronics are punched and cut by the die by the punching force generated by the machine. The characteristics of the hydraulic cutting machine: When the punching head acts on the workpiece through the die, the pressure in the working cylinder does not reach the rated pressure, and the pressure will increase as the contact (cutting into the workpiece) increases, until the electromagnetic The reversing valve receives the signal, the reversing valve reverses, and the punching head begins to reset; at this time, the pressure in the cylinder may not reach the set rated pressure due to the time limit of the pressure oil entering the cylinder; The system pressure has not reached the design value, and the die cutting has been completed.