Home > Exhibition > Content

Precautions for maintenance and maintenance of hydraulic cutting machine

Aug 08, 2018

Precautions for maintenance and maintenance of hydraulic cutting machine



Under the special condition of hydraulic cutting machine, when the press plate is immediately back up, it can press the reset button and press the power brake button (red button) when it stops. The whole system stops operation immediately. In order to ensure safety, the hands and other parts of the body are strictly prohibited in the blanking area. Before maintenance, the power supply must be closed and the wood or other hard objects are inserted in the blanking area to prevent the runaway from the pressure plate after pressure relief and cause accidental personal injury. When you operate, you must hit the two buttons on the pressure plate with your hands. You can't change one hand or pedal operation at will.

The hydraulic cutting machine is stacked in the middle of the worktable by pushing and pulling plates, rubber sheets, workpieces, and knife dies in sequence. First, the depth controller (fine-tuning knob) is left to zero. Turn on the power switch, press the oil pump start button, run no-load for two minutes, and observe whether the system is normal.

IMG_2350.JPG