Embossing Machine maintenance work
1. Before the maintenance of Embossing Machine work, you must first emboss the mechanical power supply and connect the external power supply to cut off, not live operation.
2. In the disassembly maintenance work, the workers are best not to wear earrings, watches, necklaces, bracelets and other conductive ornaments can prevent accidents.
3. Do not disassemble and inspect any parts on the Embossing Machine unless you have sufficient knowledge of the equipment performance.
4. Do not disassemble and repair embossing equipment separately unless you have other personnel to assist and in the event of an accident or damage to the machine or personal injury.
5. Only qualified personnel can work on the maintenance of the Embossing Machine.
6. In any case, do not touch the wires that may be exposed to the outside or other components that are electrically connected and are not loosened. Before removing or moving the protective device on the Embossing Machine or replacing the components, the supply of the power supply must be switched off.
7. If possible, try to stand on the plastic blanket for maintenance work. Do not carry out maintenance work on Embossing Machines in flooded floors or very humid environments.
8. For the maintenance and repair of the Embossing Machine must wear safety gloves, goggles and long-sleeved overalls, to avoid the body part of the high temperature of the liquid hot sol scald, or high temperature surface burns.
9. When loosening or installing the pressure connection, it must be determined that the pressure supplied to the Embossing Machine is reduced to zero.
10. When cleaning hot melt melt melt cylinder, avoid the use of fireworks or sharp hard tools, so as not to scratch the inside of the plastic drum Teflon non-adhesive coating.
In addition to Embossing Machine, laminating materials, the film is also very important, and the film also has a different type, how do we choose to fit their own materials,
Choose the appropriate bonding material is not enough, but also need to choose according to the different needs of the appropriate film structure. The heat-seal film is usually composed of two layers: a polyester base layer and an inner adhesive resin layer. The amount of resin and adhesive layer in hot bonding is usually expressed as a ratio, such as 3/2 or 1/4. The first number represents the polyester portion and the second number represents the adhesive layer portion. When the ratio is large, the resulting laminate is harder. And the ratio of the product obtained when the bonding is relatively strong. When the adhesive material is thick, such as the back of the photographic film or hard plastic, you need a higher bonding strength.
Embossing Machine is designed to meet the packaging requirements for storage, transportation and mechanized loading and unloading operations. It has designed and manufactured tray Embossing Machine, pressure top type pull-type Embossing Machine, pre-pull type automatic film Embossing Machine series, Widely used in foreign trade and export, food and beverage, the system of irrigation, paper, dyes, plastic chemicals, glass ceramics, electromechanical castings and other products, the cost of assembly. Embossing Machine can improve production efficiency, but also to prevent damage to the goods in the handling process, and play a dust, moisture and cleaning effect.
Embossing Machine in our industrial production area occupies an important use of the occasion, in our productive forces continue to rapid development process, our equipment performance is getting higher and higher. Ribbon Embossing Machine for sponge, cloth, EVA, leather and non-woven fabrics such as plastic. This Embossing Machine with high temperature mesh belt pressing, improve the fit smoothness, improve product adhesion, while less land. The machine adopts synchronous control of frequency conversion to realize the work of compound main drying drum and compound winding, and it is more convenient to use. The advantage of this Embossing Machine is the use of high temperature mesh with pressure, improve the product fit flatness and adhesion, easy to operate.