Home > News > Content

Embossing Machine Operation Steps And Precautions

Jun 13, 2017

Embossing Machine operation steps and precautions
Embossing Machine operation process, the operator must be familiar with the relevant production processes, skilled operation of the presses and tools, labor insurance products, wear complete, before the job. Before starting the machine to ensure that the fasteners, the operation of the parts, moving surface without obstacles, safety protection device complete. Mold seat and mold joint surface should be kept clean, no metal and other hard objects.
First of all, Embossing Machine in the operating steps are what?
1. Measure the length of the hose sample with a ruler. Measure the metal joint data with a caliper and observe the inner diameter of the hose sample. Prepare the required hose and fittings. Cut the length of the hose with a pipe cutter to clean the hose hole.
2. Use a stripper to peel off the outer layer of the hose and insert the hose into the metal fitting sleeve. The outer rubber of the hose must be stripped off. Insert the metal connector into the hose directly to the bottom. Measure whether the hose is the same length as the hose sample. Machining the hose with no taper shrinkage tube. According to the hose will be pressed by the locator to adjust the provisions of the data.
3. Start pressing the hose and you can use the manual push button or use the pedal button. Hose buckle in place, the locator can send alarm sound, and then press the open button. Withholding is completed with the caliper measured withheld data, with a probe detection. Hose to the required withholding data can be. Withholding is complete, stop, cut off the power.
Second, Embossing Machine operation process, we should pay attention to what matters?
4. Tighten the set screws before installing the module. Before starting the mold seat should be injected into the slope of lubricating oil. Do not use the cylinder over the trip, in the pressure or pressure relief if the shaking, is strictly prohibited processing. Cylinder piston jitter or oil pump sharp sound, should be discharged from the gas.
5. The regulator should be adjusted at the specified pressure and calibrated on a regular basis. It is forbidden to place the hand in the withholding position when the equipment is running. Replacement molds should be carried out after shutdown. Working oil temperature exceeds 45 ℃, should stop inspection.
Install the module before tightening the set screw. Before starting the mold seat should be injected into the slope of lubricating oil. Do not use the cylinder over the trip, in the pressure or pressure relief if the shaking, is strictly prohibited processing. Cylinder piston jitter or oil pump sharp sound, should be discharged from the gas.
6. The regulator should be adjusted at the specified pressure and calibrated on a regular basis. It is forbidden to place the hand in the withholding position when the equipment is running. Replacement molds should be carried out after shutdown. Working oil temperature exceeds 45 ℃, should stop inspection.