Home > News > Content

Rapid Response Method Of Hydraulic Die Cutting Machine

Jun 13, 2017

Rapid response method of Hydraulic Die Cutting Machine
Hydraulic die-cutting machine in the course of the use of a variety of emergencies, such as the situation in the work of the situation, the need for hydraulic die-cutting machine to check to find out the reasons for the error, the general experience of the relevant work Personnel can quickly find out the cause of the failure, of course, this requires maintenance personnel to have a deep understanding of the hydraulic system, familiar with the structure of hydraulic components and working principle. Of course, this is a long time, maintenance personnel usually can ask, see more, listen and other methods to better understand the equipment, so as to be able to find the problem in time to deal with failure. So the use of the process must pay attention to maintenance, so as to ensure that the hydraulic die-cutting machine on the various components to normal operation. Or long-term maintenance does not cause irreversible damage, not only affect the production, but also reduce the hydraulic die-cutting machine life.
 1. An emergency fault handling method occurs
 
If you can not immediately replace the parts after the replacement of the problem, you can use the alternative method, with some other parts related to temporary use, after the end of the day in the original replacement. In addition to the emergency repair method, it is best to pay attention to the use of methods and maintenance, so as to avoid this situation as much as possible.
 
In the winter and worse operating conditions, to the hydraulic die-cutting machine system check, maintenance. Often change the working fluid. In the hydraulic drive system, are some of the more sophisticated parts. The hydraulic system has three basic pathogenic factors: contamination, overheating and entry into the air. Practice has proved that the hydraulic system 75% of the causes of the disease are caused by these three reasons. So be sure to do the equipment maintenance work, so that hydraulic die-cutting machine can work faster and better.
 
2. Use the maintenance method in the process
 
First, every month to check the worm, worm, bearings, pressure roller, upper and lower rails and other activities are flexible part of the rotation, whether wear, if damaged should be replaced in time repair.
 
Two, three months to clean the hydraulic valve and fuel tank, check or replace the seal, filter. Filter the hydraulic oil every 3 months, or replace the new hydraulic oil. Such as the use of frequency is not high, may be appropriate to extend.
 
Third, the powder hydraulic die-cutting machine should be removed after the remaining powder. Brush the residual powder of each part of the machine.
 
Fourth, do not use the mold should be applied to the surface of the mold oil or all immersed in oil, keep clean, do not make rust and bumps. The following are the same as the "
The following are the same as the "
Fifth, the electrical cabinet to regular inspection, cooling fan should be regularly used to remove dust from the compressed air. Electrical components should pay attention to working conditions (temperature, humidity), in a good environment, will extend the service life of parts. Electrical components of the maintenance, should be implemented by a professional electrician, in particular, should be more carefully engaged in the inverter, under normal circumstances should be sent to professional manufacturers maintenance.
 
6, the hydraulic die-cutting machine electrical components to do insulation testing, the inverter must be the main circuit control circuit wiring all removed, so as not to damage the inverter insulation test. For the inverter insulation test method alone see the inverter operating manual.