The setting of the cutter height of the cutting machine
1. Remove the sundries on the work table and place the die in the center of the rubber plate.
2. After the machine is opened, the handwheel will be set aside and "left to zero pressure".
3, turn the set switch right to the "knife mode setting" direction, and cut the press plate 13 to start slowly down to the tight knife die then automatically stop.
(44, push the handwheel to the bottom and tighten it. Set the switch left rotation before the start) and turn to the "position cutting".
5, then press the brake switch, and the cutting plate will pick up immediately to the highest position, and the tool die is set at this time.